Technical data

237
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\referenc.fb
Chapter 5, Reference (Alphabetical)
USER Keys
Run Test loads and runs the program that is called from the procedure that has
been entered into the TESTS screen
Select Procedure Filename: entry. If
the program is already loaded into the test set’s memory, it will be started.
Save Proc is used to save the specified procedure.
Sngl Step steps the IBASIC program one line at a time. This is different from
Continuous/Single Step run mode. See "Test Execution Conditions" on page
234
.
Stop Test pauses the test software.
Take It causes the program to accept the setting of an adjustment, and proceed
with the program. The test, determining if the adjustment is within limits, is
ceased.
Yes\No are pressed when answering questions displayed on the test set’s CRT
display.