Technical data

235
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\referenc.fb
Chapter 5, Reference (Alphabetical)
Test Execution Conditions
If Unit-Under-Test Fails (If UUT Fails)
You can select either: Continue or Stop Default:Continue
If you set this to
Stop, and a pass/fail result is F, the program will stop.
Test Procedure Run Mode (Run Mode)
You can select either: Continuous or Single Step Default:Continuous
You can make tests pause at certain times. If you set this to
Single Step, the
program will pause after a comparison is made between a test determination and
the expected result. For example, tests will pause after the program compares the
results to a specification. You can continue from the paused state by pressing k2
(
Continue).
Autostart Test Procedure on Power-Up
You can select either: On or Off Default: Off
You can set up the test set so that if the procedure was previously loaded, the
procedure will be immediately executed when the test set is powered on.