Technical data

217
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\referenc.fb
Chapter 5, Reference (Alphabetical)
Printing
The software already has an implied escape character for the first sequence, you
need only to enter the escape sequence following the escape character. However,
if you are linking two or more sequences together, you must use the
~ to indicate
the escape character between each sequence. If the sequence exceeds the space
allotted in the options field, you may continue with additional escape sequences in
the next available
Options field. You must however, still enter Escape Seq in
the
Calling Name field and the appropriate address in the Addr field for all
subsequent entries.
How to send an
Escape
Sequence:
1. Press TESTS.
2. Select External Devices from the SET UP TEST SET list.
3. Position the cursor to the Inst# field and select it.
4. Rotate the knob until an empty Calling Name field appears, and select it.
5. Position the cursor to the Calling Name field and select it.
6. Select Escape Seq from the Choices menu.
7. Position the cursor to the Addr (address) field and select it.
8. Using the DATA keypad, enter 9 for serial printers, 15 for parallel printers, or 70X for
HP-IB printers, then press ENTER. .
9. Position the cursor to the Options field (directly under Calling Name) and select
it.
10. Select the desired escape sequence from the Choices menu if applicable, or enter an
appropriate sequence using the list of characters below the choices.