Technical data

215
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\referenc.fb
Chapter 5, Reference (Alphabetical)
Printing
Configuring the Test Set for Printing
If using a serial printer, you cannot use the serial port for other connections at the
same time, such as Data Collection (saving test results). Serial port connections
are shown earlier in this section.
NOTE: Printer Setup Differences
The HP 8920A,D had several firmware enhancements, which are standard in the
HP 8920B. The following Setup Printer section applies to users with:
• HP 8920A,D test sets with firmware above revision A.14.00.
• All HP 8920B test sets.
The test set’s firmware revision is displayed on the top right corner of the
configuration screen.
• Press SHIFT CONFIG to display the configuration screen and read the firmware
revision.
If you have an HP 8920A with firmware revision below A.14.00, refer to the next
section titled "To Setup Printer Using HP 8920A FW Below Rev A.14.00" on
page 220. Contact Hewlett-Packard at 1-800-922-8920 for details on upgrading
your firmware if desired.
NOTE: EXCEPTION: If you are using A.xx.xx revision software, you can not use the Printer
Setup screen regardless of your firmware revision. Refer to the instructions for firmware
below A.14.00.