Technical data

200
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\referenc.fb
Chapter 5, Reference (Alphabetical)
Exiting a Program
Exiting a Program
Do not press RX or TX to exit the program. Selecting the RX TEST or TX TEST
screen causes signal paths internal to the test set to be modified. If you exit the
program to a screen other than RX TEST or TX TEST, the settings necessary to
resume testing will be retained.
After you have made the manual settings you want, press the DUPLEX key as a
last step before continuing the software. This will cause the test set to be properly
set up.
Another way to safely exit is to:
1. Press CANCEL.
2. Press DUPLEX.
3. Press SHIFT SAVE.
4. Using list of characters in the Choices menu, enter a register name or number.
5. Select Done.
6 Operate the test set manually.
7. Press RECALL.
8 Choose the name of the saved setup.
9. Press TESTS.
10. Press k2 (Continue).