Technical data

181

S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb

Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions

Pass/Fail Limit 37, TX Output Power at Low Supply Low SW

This sets the pass/fail limits for testing the transmitter at its low-switch setting

with the power supply set to its low-power setting.

Pass/Fail limits are determined from an applicable radio specification or industry

standard, such as:

• Radio specification: RF Power

• Industry standard: EIA/TIA-603, Section 2.2.1, Carrier Power Output Rating

For Example:

If your radio specification defines the RF output power as 2 Watts at its low-

switch setting with the power supply at its low-power setting and you want to test

both limits on your radio, you might enter

1 in the lower-limit column and choose

an appropriate upper-limit, for example

3 Watts. Limits are entered in Watts.

It’s Used in the Following Tests:

TEST_03. TX Output Power

TEST_21. TX Quick Test