Technical data

158 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Pass/Fail Limit 14, RX Stand-by Current Drain
Pass/Fail Limit 14, RX Stand-by Current Drain
This sets the pass/fail limits for testing a receiver’s stand-by current drain (with
squelch set to maximum).
Pass/Fail limits are determined from an applicable radio specification, such as:
• Radio specification: Maximum Battery Drain
For Example:
If your radio specification defines the maximum battery drain, while the radio is
receiving, as 0.5 amps and you want to test the radio’s upper limits only, enter
0 in
the lower-limit column and
0.5 in the upper-limit column. Limits are entered in
Amps.
It’s Used in the Following Test:
TEST_01. TX and RX Stand-by Current Drain