Technical data

144 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb

Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions

Pass/Fail Limit Descriptions (specifications)

Pass/Fail Limits define the values a measurement’s result is compared against to

determine if the UUT meets its specified standards.

For information on editing Pass/Fail Limits,

see "Customizing Testing," in chapter

2, on page 32

The list of pass/fail limits is arranged alphabetically. The first few capital letters in

the title of each pass/fail limit indicate what the pass/fail limit refers to.

Pass/Fail Limits remain in battery-backed-up memory until you select a procedure

to run. If you wish to prevent them from being lost when a new procedure is

selected you will have to save them in a procedure.

See "Saving a Test Procedure,"

in chapter 2, on page 50

. To print the list of Pass/Fail Limits, see "To print TESTS

screens:," in chapter 5, on page 219

There are two types of pass/fail limits:

• Receiver Test Pass/Fail Limits (RX)

• Transmitter Test Pass/Fail Limits (TX)

NOTE: Refer to chapter 2 in this manual for details about selecting pass/fail limits for your FM

radio.