Technical data

142 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Parameter 32, TX User/System Key UUT
Parameter 32, TX User/System Key UUT
This test parameter allows you to determine if the test operator (user) keys the
transmitter or if the test set (system) keys the transmitter during testing. Having
the test set key the transmitter requires connections from the radio to the test set’s
MIC/ACC connector (refer to
chapter 2, "Using the Software/HP 8920B or HP
8920A FW Above Rev. A.14.00," on page 23
).
For Example:
If you want the test set to automatically key the transmitter, enter
1 in the value
column, otherwise, enter
0 in the value column.
It’s Used in the Following Tests:
All transmitter tests if this test parameter is turned on (that is, set to
1).