Technical data

140 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Parameter 30, TX Modulation Limiting Sweep Step Freq
Parameter 30, TX Modulation Limiting Sweep Step Freq
This test parameter sets the step-size used to vary the modulation frequency for
testing transmitter modulation limiting.
For Example:
If your industry standard determines that the modulation frequency in the
modulation limiting test should be varied from 300 Hz to 3000 Hz and you want
to measure only one step, enter
2.7 in the value column. The value is entered in
kHz.
It’s Used in the Following Test:
TEST_04. TX Modulation Limiting