Technical data

128 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb

Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions

Parameter 16, RX Standard RF Input Level

This test parameter sets the standard RF input level (which is the test set’s RF

generator’s output level) that is used in receiver testing.

For Example:

The EIA standard specifies the standard input-signal level as 60 dB above the

reference (usable) sensitivity. The reference sensitivity is specified for each RF

band.

If your radio was specified for 1 µV sensitivity, then the input level should be 60

dB above that or 1000 µV. In this case, enter

1000 in the value column. The value

is entered in µV.

It’s Used in the Following Tests:

TEST_11. RX Hum and Noise

TEST_12. RX Audio Distortion

TEST_13. RX Audio Frequency Response

TEST_14. RX Usable Sensitivity

TEST_15. RX Audio Squelch Sensitivity

TEST_16. RX Squelch Blocking

TEST_17. RX CTCSS/CDCSS Opening

TEST_18. RX Audio Sensitivity

TEST_19. RX Variation of Sens with Freq

TEST_20. RX Quick Test