Technical data

126 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb

Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions

Parameter 14, RX Squelch Control

Depending upon how you set this test parameter, the test operator is either

prompted to adjust the squelch control on the radio during testing, or the software

is allowed to take the squelch setting where it is at.

Besides being used in the test shown below, a subroutine in the software uses this

test parameter whenever the test operator is prompted to adjust the radio squelch

control.

For example:

If you want the test operator to be able to adjust radio squelch during testing, enter

1 in the value column. If you want the test set to take the squelch setting as it is,

enter

0 in the value column.

It’s Used in the Following Test:

TEST_11. RX Hum and Noise