Technical data

124 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Parameter 12, RX Set Radio Volume
Parameter 12, RX Set Radio Volume
This test parameter prompts the test operator to adjust volume on the radio during
testing or allows the software to take the volume setting as it is.
You can decrease testing time by setting this test parameter to
0=no if you are
willing to let the tests run at the same volume (audio) level. The industry standard
often requires adjusting volume to specific volume levels.
For example:
If you want the test operator to adjust the radio’s volume during testing, enter
1 in
the value column. If you want the test set to take the volume setting as it is, enter
0
in the value column.
It’s Used in the Following Tests:
All receiver tests where adjusting volume is required.