Manualshelf

Technical data

ManualsBrandsAgilent Technologies ManualsConsumer electronics665xA Series
111112113114115116117118119120
117
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Parameter 5, RT Nominal Supply Voltage
Parameter 5, RT Nominal Supply Voltage
This test parameter sets the nominal (that is, normal) power-supply voltage
required by the radio. Besides being used in the tests shown below, this test
parameter is used whenever the test set is initialized prior to starting a Test
Procedure.
For Example:
If your radio specification lists the nominal supply voltage to be +13.2V, enter
13.2 in the value column. The value is entered in Vdc.
It’s Used in the Following Tests:
TEST_03. TX Output Power
TEST_21. TX Quick Test