Technical data

114 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb

Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions

Parameter 2, RT Full Rated System Deviation

This test parameter sets the full-rated (maximum) deviation used by the test set

during receiver and transmitter tests.

Besides being used in the tests shown below, full-rated system deviation is set on

the test set by subroutines in the software whenever:

❒ the test set is set to the standard receiver mode.

❒ transmitter deviation is set on the test set.

For Example:

If your industry standard specifies the full-rated system deviation to be 5 kHz,

enter

5 in the value column. The value is entered in kHz.

It’s Used in the Following Tests:

TEST_04. TX Modulation Limiting

TEST_05. TX Audio Frequency Response

TEST_06. TX Audio Distortion

TEST_07. TX Microphone Sensitivity

TEST_08. TX FM Hum and Noise

TEST_11. RX Hum and Noise

TEST_13. RX Audio Frequency Response

TEST_16. RX Squelch Blocking

TEST_18. RX Audio Sensitivity