Technical data

2 Operation and Features
Overview
32 E364xA User’s and Service Guide
Overview
The following section describes an overview of the front
panel keys before operating your power supply.
• The power supply is shipped from the factory configured
in the front panel operation mode. When in this mode,
the front panel keys can be used. At power- on, the power
supply is automatically set to operate in the front panel
operation mode and the output1 is selected for front
panel operation. Press
for the output2 front
panel operation.
• When the power supply is in the remote operation mode,
you can return to the front panel operation mode at any
time by pressing the
(Local) key if you did not
previously send the front panel lockout command. A
change between the front panel and remote operation
modes will not result in a change in the output
parameters.
• When you press (the Limit annunciator flashes), the
display of the power supply goes to the limit mode and
the present limit values will be displayed. In this mode,
you can also observe the change of the limit values when
adjusting the knob. If you press
again or let the
display time- out after several seconds, the power supply
will return the display to the meter mode (the Limit
annunciator turns off). In this mode, the actual output
voltage and current will be displayed.
• The output of the power supply can be enabled or
disabled from the front panel by pressing
. When the
output is off, the OFF annunciator turns on and the output
is disabled.
2
Local
Store
Display
Limit
Display
Limit
On/Off
Output