Technical data

Remote Interface Reference 3
Output Settings and Operation Commands
E364xA User’s and Service Guide 89
VOLTage:STEP {<numeric value>|DEFault}
Set the step size for voltage programming with the VOLT UP
and VOLT DOWN commands. See the example below.
To set the step size to the minimum resolution, set the step
size to DEFault. The minimum resolution of the step size is
approximately 0.35 mV (E3646A), 1.14 mV (E3647A),
0.38 mV (E3648A), and 1.14 mV (E3649A), respectively.
The immediate voltage level increases or decreases by the
value of the step size. For example, the output voltage will
increase or decrease 10 mV if the step size is 0.01. At *RST,
the step size is the value of the minimum resolution.
VOLTage:STEP? [DEFault]
Return the value of the step size currently specified. The
returned parameter is a numeric value. DEFault gives the
minimum resolution step size in unit of volts.
Example
The following program segments show how to use the VOLT
UP or VOLT DOWN command to increase or decrease the
output voltage with the VOLT:STEP command.
VOLTage:TRIGgered
{<voltage>|MINimum|MAXimum}
Program the pending triggered voltage level. The pending
triggered voltage level is a stored value that is transferred to
the output terminals when a trigger occurs. A pending
triggered level is not affected by subsequent VOLTage
commands.
VOLT:STEP 0.01 Set the step size to 0.01 V.
VOLT UP Increase the output voltage.
VOLT:STEP 0.02 Set the step size to 0.02 V.
VOLT DOWN Decrease the output voltage.