Technical data

3 Remote Interface Reference
Output Settings and Operation Commands
88 E364xA User’s and Service Guide
MEASure:CURRent?
Query the current measured across the current sense
resistor inside the power supply.
MEASure[:VOLTage]?
Query the voltage measured at the sense terminals of the
power supply.
OUTPut:TRACk[:STATe] {ON|OFF}
This command enables or disables the power supply to
operate in the track mode. See “Track Mode Operation” on
page 38 for more information on tracking operation. At
*RST, the track mode is disabled.
OUTPut:TRACk[:STATe]?
Query the tracking mode state of the power supply. The
returned value is 0 (OFF) or 1 (ON).
VOLTage {<voltage>|MINimum|MAXimum|UP|DOWN}
This command programs the immediate voltage level of the
power supply. The immediate level is the voltage value of the
output terminals.
The VOLTage command changes the output of the power
supply to the newly programmed value regardless of the
output range presently selected. This command also
increases or decreases the immediate voltage level using the
“UP” or “DOWN” parameter by a predetermined amount. The
command VOLTage:STEP sets the amount of increment or
decrement. Notice that a new increment setting will cause an
execution error - 222 (Data out of range) when the maximum
or the minimum rated voltage is exceeded.
VOLTage? [MINimum|MAXimum]
Query the presently programmed voltage level of the power
supply.