Specifications

85
Command processing time: Average time
required for the output voltage to begin
to change following receipt of digital
data is 20 ms for the power supplies
connecteddirectlytotheGPIB.
(Display disabled.)
Output voltage rise time/fall time:
100 ms/200 ms for output to change from
90% to 10% or from 10% to 90% of its total
excursion with full resistive load
(excludes command processing time).
Modulation: (Analog programming of
output voltage and current)
Input signal: 0 to -4 V for voltage
and current
Input impedance: 60 k nominal
Input power: 3800 VA, 2600 W at full load;
100 W at no load
GPIB interface capabilities: SH1, AH1, TE6,
LE4, SR1, RL1, PP0, DC1, DT1, E1 and
C0. IEEE-488.2 and SCPI-compatible
command set
Software driver:
•IVI-COM
•VXIPlug&Play
Regulatory compliance: Listed to UL1244;
certifiedtoCSA556B,conformsto
EN61010.
Warranty: Three years
Size: 425.5 mm W x 132.6 mm H x
640 mm D
Weight: 27.7 kg (61 lbs) net,
31.4 kg (69 lbs) shipping.
Ordering information
Opt 200 174 to 220 VAC, 47 to 63 Hz
(Japan only)
Opt 230 191 to 250 VAC, 47 to 63 Hz
Opt 0L1 English printed operating
manual (full documentation on
CD-ROM)
Opt 0B3 English printed service manual
A line cord option must be specified,
see the AC line voltage and cord section.
Single-Output: 2000 W GPIB
(Continued)
More detailed specifications at www.agilent.com/find/E4356
High Performance DC Power Supplies speed and accuracy for test optimization
Accessories
* 1CM003A Rack mount flange kit
132.6 mm H (3U) - two flange brackets
* 1CP002A Rack mount flange and handle
kit 132.6 mm H (3U) - two brackets and
front handles
p/n 1494-0059 Accessory slide kit
p/n 1252-3698 7-pin analog plug
p/n 1252-1488 4-pin digitial plug
p/n 5080-2148 Serial link cable
2 m (6.6 ft)
E3663AC Support rails for Agilent
rack cabinets
* Support rails or slides are required
Agilent Models: E4356A
425.5mm
16.75"
574mm
22.6"
640mm
25.4"
68mm
2.67"
132.6 mm
5.2"
145.1 mm
5.71"
Accepts
Top
Side
12.7mm
0.5"
128mm
5.04"
Accepts Wire
AWG 12-22
1/4" x 1" untreaded
hole on each bussbar
Note: Buss Bar is 1/8" thick cu
1.25"
0.75"
0.31 dia"
1.0"
0.5"
IM
VP
+IP
-IP
+P
+S
-S
-LS +LS
Rear
Rear Connector Detail
Buss Bar Detail