Specifications

48 System Instrument Configuration Chapter 2
Programmable Power Supplies
The programmable power supplies, or UUT power supplies, include the
Agilent 6642A, 6643A, 6652A, 6653A, 6672A. and 6673A power supplies.
These supplies provide power to the unit under test.
GPIB Address
Selection
The first UUT power supply in the system should have a GPIB address
number 5. The second power supply should be set to GPIB address 6, and
the third power supply to address 7. If you need to change the power
supply’s address, refer to user manual for that power supply. You must add
the address information to the ‘
SYSTEM.UST’ configuration file. Refer to
“Adding Instruments to the system.ust File” on page 55, for specific
information on updating the configuration file.
Agilent 6642A DC
Power Supply
The Agilent 6642A DC Power Supply is a 1-output, 0-20 volt, 0-10 A GPIB
supply. You can set the supply to 100 volts, 120volts, 220 volts, and 240
volts ac line voltage input by setting the line voltage select switches. Refer
to the Agilent 6642A Power Supply User Manual for specific information.
Agilent 6643A DC
Power Supply
The Agilent 6643A DC Power Supply is a 1-output, 0-35 volt, 0-6 A GPIB
supply. You can set the supply to 100 volts, 120volts, 220 volts, and 240
volts ac line voltage input by setting the line voltage select switches. Refer
to the Agilent 6643A Power Supply User Manual for specific information.
Agilent 6652A DC
Power Supply
The Agilent 6652A DC Power Supply is a 1-output, 0-20 volt, 0-25 A GPIB
supply. The supply can be set to accept 100 volts, 120volts, 220 volts, and
240 volts ac line voltage input by changing wire and jumper locations on the
ac input of the main power transformer. Refer to the Agilent 6652A Power
Supply User Manual for specific information.
Agilent 6653A DC
Power Supply
The Agilent 6653A DC Power Supply is a 1-output, 0-35 volt, 0-15 A GPIB
supply. The supply can be set to accept 100 volts, 120volts, 220 volts, and
240 volts ac line voltage input by changing wire and jumper locations on the
ac input of the main power transformer. Refer to the Agilent 6653A Power
Supply User Manual for specific information.
Agilent 6672A DC
Power Supply
The Agilent 6672A DC Power Supply is a 1-output, 0-20 volt, 0-100A GPIB
supply. It is not switchable to multiple line voltages--it is set up for 220 - 240
volts and is connected to the Agilent E1135A PDU.
Caution The maximum current draw capability of the Agilent 6672A
exceeds the breaker size (15A) on the Agilent TS-5400 system
and the design specifications of the load cards. Do not use the
maximum capabilities of the Agilent 6672A through the
Switch/Load Unit.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com