Specifications

36 System Instrument Configuration Chapter 2
Agilent E1411B
Digital Multimeter
Module
The Agilent E1411B Digital Multimeter (DMM) Module comes standard
with the Agilent TS-5400 System. The DMM measures dc voltage, ac-rms
voltage, and ohms (including 4-wire ohms). It can also measure temperature
by using thermistors. In addition to test measurements, the DMM serves as
the system reference and is used to calibrate the V/I functions. The DMM
input is balanced and differential.
Switch/Jumpers Settings Figure 2-2 shows the Agilent E1411B logical address switch with the switch
shown in the factory setting. Set the logical address to match the VXI
mainframe slot number for a one mainframe system. For a two mainframe
system, set to the slot number plus 16, if in mainframe #1, or to the slot
number plus 32, if in mainframe #2. Refer to “VXI Module Locations And
Logical Addresses” on page 32. The Interrupt Priority is always set to 1.
Figure 2-2. Agilent E1411B DMM Module and Cables
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com