Specifications

34 System Instrument Configuration Chapter 2

VXI Modules

This section describes the individual VXI modules used in an Agilent

TS-5400 system, the switch and jumper settings, and cabling to the modules.

For additional information on any of these modules, refer to the user’s

manual included with each module.

Before installing a new or replacement VXI module in a mainframe, verify

that its switches or jumpers are set as shown in this section. DO NOT assume

that the factory settings are correct; you may have to change the factory

settings for this application in the Agilent TS-5400 system.

Note In the following descriptions, the factory default Logical Address is the

address that an exchange module or new non-system integrated module is

normally set to. The Agilent TS-5400 Logical Address is the logical

address of a module installed in a Agilent TS-5400 system.

The following modules are included or are optional:

• Agilent E1333A 3-Channel Universal Counter Module. . . . page 35

• Agilent E1411B Digital Multimeter Module . . . . . . . . . . . . page 36

• Agilent E1418A 8/16-Channel Digital/Analog Converter Module

page 37

• VXI Technology E1563A 2-Channel 800 ka/s Digitizer (ADC)

Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 39

• VXI-MXI-2 Interface Module . . . . . . . . . . . . . . . . . . . . . . . page 42

• Agilent E6171B Measurement Control Module. . . . . . . . . . page 43

• Agilent E6173A Arbitrary Waveform Generator (ARB) Module page

• Agilent E6174A Event Detector Module . . . . . . . . . . . . . . . page 47

Refer to Chapter 4 on page 63 for wiring and cable pinout diagrams. Refer

also to the mass interconnect manual supplied with your test system.

WARNING To prevent electric shock hazard, the module face plate must be

securely fastened to the mainframe.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com