Specifications

102 Calibration and Preventive Maintenance Chapter 6
10.Select the OK button in the adjustment box. Note: select the
CANCEL button if you are unable to center the vertical bar.
11.System adjustment is complete.
Adjustment Procedure
for Agilent E6171B
Modules
Agilent E6171 Revision B Modules have the resistor standard built into the
module; no test fixture is required.
1. Remove the 4" ribbon cable from the J2 connector on the front of the
Agilent E6171B module. Fold and connect the ribbon cable to the J2
connector on the Agilent E6171B. See Figure 6-5.
Figure 6-5. Agilent E6171B Calibration Setup
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com