User`s guide

1 - Quick Reference
14
The Rear Panel - At a Glance
1 AC calibration switch
(see appendix B).
2 GPIB (IEEE-488)
interface connector.
3 RS-232 interface
connector.
4 INH/FLT (remote
INHibit / internal
FauLT) connector.
Connector plug is
removable.
WARNING:
NO OPERATOR SERVICEABLE PARTS INSIDE, REFER SERVICING TO SERVICE TRAINED PERSONNEL.
WARNING:
FOR CONTINUED FIRE PROTECTION, USE SPECIFIED LINE FUSE
-S
-+
+S
Local
Remote
SENSE
+
-
50VDC MAX TO
RS 232
INH FLT
+
-+
LINE
FUSE
120V
1A
250V
RATING
000VA
50/60 Hz
FUSE
AC - I CAL
| Normal
/ Hold to Cal
2 3 4
5 6
1
7 8
5 Output and Remote
sense connector.
Connector plug is
removable.
6 Remote or Local
sense switch
7 Fuse holder 8 Power cord connector
(IEC 320)
Instrument Configuration
Use the front panel Address key to configure the interface
Refer to “Front Panel Menus - At a Glance”
♦ Select either the GPIB or RS-232 interface.
♦ Enter the GPIB bus address.
♦ Configure the RS-232 baud rate, parity, and flow control.
♦ Select either the SCPI or COMPatibility programming language.
♦ Enable the optional Agilent 14575A remote front panel.