User`s guide

User’s Guide 83
Stop current run and sequence run
This selection stops the run currently in progress, and
terminates the sequence it is a part of. Other queued
items will proceed.
Stop sequence after current run completes
This selection will abort the sequence after the
current run in progress is completed.
Stop all run queue items you submitted
This selection stops the run currently in progress, and
terminates all the items in the queue that were
submitted by you. Queue items submitted by other
users will be unaffected.
Stop all run queue items
This selection stops the run currently in progress, and
terminates all items in the run queue.
Note: When a run is stopped, the data up to that point is saved in
the data file. However, no analysis of the data will be
performed. If you want to produce a report or view results
from a run that was stopped, you must Analyze the data file.
Note: If you are not the user that submitted the run or sequence or
are using an instrument offline, you do not have access to the
Stop command.
Extend a Run
While a run is in progress, you can extend the data
acquisition beyond the designated run time by
1. From the menu, click Control followed by Extend
Run.
2. A dialog will appear where you can enter the amount
of time by which you wish to extend the run.
3. Enter the number of minutes you wish to extend the
run, and then click the OK button.