User`s guide

User’s Guide 81
Seq. w/ Back Calc Select this if you want to perform
the sequence mode of bracketing calibrations and
back-calculate calibration runs.
Review
Results Review
Click this box if you want the sequence to pause
between runs for you to review results.
Calibration Review
Click this box if you want the sequence to pause after
each calibration set, where a calibration set is defined
as one or more calibration runs that occur in a
sequence.
Printing
Print Method Reports
Click this box if you want the custom report defined
in the method to be printed for each run of the
sequence.
Print Sequence Reports
Click this box if you want sequence reports to be
printed.
Begin run
By default, run will start immediately. If you want to
schedule the start of the sequence for a later time or
date, click the
button to open the Schedule Run
dialog where you can enter or select the time to start
the sequence.
Email Recipient(s)
Use this field to enable email notification to be sent to
a designated address (entered in the To: field).
Select the On Start box to send email notification
when the sequence starts.