User`s guide

80 User’s Guide
Range
Enter a range of runs to be executed. For example, an
entry of 4 - 6 will execute runs 4, 5, and 6 of the
sequence. An entry of 4- designates the 4
th
run
through the end of the sequence.
Mode
Select the manner by which you want to handle
autosampler dual towers (if any), processing mode,
and bracketed calibration (if used).
Tower
If your instrument is configured for Dual Tower, you
can select the tower mode to be used for the sequence
run. Selections include Dual, Front, and Rear.
Processing Mode
Select a mode for reprocessing the data. Options here
will vary depending on the instrument configured. If
the instrument does not support this feature, this
option will be grayed out. For certain instruments,
Overlap Sample Prep mode will be available. See
About Overlap Sample Prep for information and
restrictions for using this mode.
Bracketing
Select the type of bracketing you wish to perform.
(See Bracketed Calibrations for details.)
None Select this if you do not wish to bracket
calibrations.
Standard Select this if you wish to perform the
standard mode of bracketing calibrations.
Std. w/Clear Calib Select this if you wish to perform
the standard mode of bracketing calibrations, clearing
the calibration before the start of each calibration set.
Sequence Select this if you want to perform the
sequence mode of bracketing calibrations.