User`s guide

User’s Guide 77
Internal Standard Amount
For calibration runs, the Internal Standard Amount is
taken from the method Peak Table. For unknown
runs, enter the amount of the Internal Standard in
your unknown sample.
Multiplication Factors
Enter one to three multiplication factors to be used
for this run. All quantitated peaks will be multiplied
by these factors.
Dilution factors
Enter one to three dilution factors to be used for this
run. All quantitated peaks will be divided by these
factors.
Calibrate
Select this box if the sample is to be a calibration
sample. Once this box is clicked, the following fields
and options will be available.
Calibration Level
Enter the number of the calibration level represented
by this calibration standard. If this is a single level
calibration, enter 1.
Clear all calibration
Click this box if you want to clear all existing
calibration factors from your method before running
the sample.
Clear calibration for level
Click this box if you want to clear the existing
response factors for this level only before running the
sample.
Print calibration report
Click this box if you want to print a calibration report
after running the sample.