Technical data

5. Disconnect the computer from the network and change the
TCP/IP settings to use the static IP address 192.168.1.2.
Contact a network administrator if you need assistance
doing this.
6. Connect one end of the supplied network crossover cable
(Part Number G4690-60000) to the computer and the other
end to the AIC network port shown in Figure 1. Be sure to
use the network port indicated in Figure 1 — The PCI
network interface card installed in the AIC 5000 is reserved
exclusively for connecting instruments to the unit.
7. Verify that the 115V/220V voltage selector is set correctly for
your location. (See Figure 1.)
8. Connect the AIC 5000 to a properly grounded AC outlet
using the supplied power cable. (See Figure 1.)
Figure 1. AIC 5000 Connections
9. Power on the AIC 5000 and wait for initialization. The AIC
5000 produces a two-tone beep when initialization is
complete.
4 Installing the AIC 5000