Technical data

10 Updating an AIC
This section applies only to the Revision A and Revision B versions
of the Agilent Instrument Controller.
For support purposes, it may occasionally be necessary to replace
the compact flash on the Agilent Instrument Controller. To do this,
use the following procedure.
1. Turn OFF and unplug the AIC.
2. Locate the compact flash on the upper rear of the AIC and
remove the plate covering it with a small screwdriver.
3. Push the ejector button with the tip of a pen or a small
screwdriver to remove the existing compact flash card.
4. Insert the update compact flash card.
5. Plug in and turn ON the AIC and complete the steps for
Installing the Agilent Instrument Controller described in
Section 2 above.
11 Notes
Please review the following notes regarding use of the Agilent
Instrument Controller.
• Before the addition or removal of a USB component,
please turn off the AIC, unless instructed otherwise.
Installing AIC Revision A 33