Technical data
details on how to connect an instrument to the SS420x, see the
documentation provided with the SS420x.
Finish Configuring the Instrument Controller
1. From the OL Explorer, go to the Administration tab, choose
Global Administration, and double click the Agilent
Instrument Controller.
2. In the list of Agilent Instrument Controller units, double
click on the Agilent Instrument Controller name that you
entered earlier.
3. Wait until you see a “Ready” status for the AIC before
proceeding. After the Agilent Instrument Controller has
finished re-initializing and shows a “Ready” status, you will
need to make sure to install all instruments or A/D devices
to be used and then set up the Agilent Instrument Controller
to recognize these devices. (See Select Components section
below.) Click Submit to continue.
Select Components
Before you can use the Agilent Instrument Controller, you must tell
it what instrument components will be in use, so the Agilent
Instrument Controller can communicate with them. The following
steps are used to select the components.
1. From OL, select the Administration tab and then click
Global Administration, followed by Agilent Instrument
Controller.
2. Double-click the name of the Agilent Instrument Controller
where the instruments are connected and then select the
Components tab.
3. Select each hardware component for this Agilent Instrument
Controller by clicking the box adjacent to the component
name. You may select as many components as you wish. If
you are using analog acquisition with an SS420x, select
Generic System.
4. Press the Submit button to finish. If this is the first
installation, after selecting the components and clicking
Submit, click the Install Now button. You will be prompted
Installing AIC Revision A 27