Technical data

several possibilities, given below. Once you have resolved
the problem, go back to the beginning of this section and
repeat the steps to set up the AIC.
• The address for the OL server was entered
incorrectly. On some networks, it may be necessary
to enter a fully-qualified name (for example
http://aspen.agilent.com).
• The laboratory network cable was not connected
soon enough after clicking Initialize (see steps 5-6,
above).
Install the SS420x
If your instrument provides an analog detector signal, you must use
the SS420x analog to digital converter box. If you are using a digital
instrument, you do not need an SS420x.
Connect the SS420x interface to the Agilent Instrument Controller
using the serial communications cable provided. Connect one end of
the cable to the serial port on the back of the SS420x. Connect the
other end of the cable to the serial port on the Agilent Instrument
Controller (see Figure 1.) Make sure each connector is tightened.
Plug the SS420x power supply into an appropriate electrical outlet.
Connect the power cord from the power supply into the receptacle
on the rear of the SS420x.
The red power LED should light. The four (4) green channel
indicator LED’s will sequentially light up during the power-up test.
When the test is complete, the green LED’s will go off and the
interface is ready to use. If this sequence does not successfully
complete, the SS420x must be powered off and then on again.
Connect the Instruments
Connect the instruments you will be using with the Agilent
Instrument Controller. If you are using a digital instrument, connect
it to the Agilent Instrument Controller using the appropriate
connector on the back of the Agilent Instrument Controller (see
Figure 1.)
18 Installing AIC Rev. B