Technical data

Important notes for the Reset to Factory Adapter
• The Reset to Factory Adapter will cause a reset to factory
defaults on any AIC, not just the one it was delivered with.
• It can be reused any number of times.
• Plug the Reset to Factory Adapter in AFTER the AIC is
powered on. Don’t plug it in before turning on the AIC.
• The Reset to Factory Adapter must be connected to start the
reset to factory, but it must not be connected for the restarts
of the AIC that are involved in the automatic reset to factory
procedure.
• After a reset to factory, the IP address of the AIC will be
reset to 192.168.1.1.
5 Replacing an AIC Revision A or B
If you are replacing an AIC Revision A or Revision B with an AIC
5000, install the AIC 5000 by following the instructions in “Installing
the AIC 5000 for Agilent OL”, above.
12 Installing the AIC 5000