Technical data

1. From OL, select the Administration tab and then click
Global Administration, followed by Agilent Instrument
Controller.
2. Double-click the name of the Agilent Instrument Controller
where the instruments are connected and then select the
Components tab.
3. Select each hardware component for this Agilent Instrument
Controller by clicking the box adjacent to the component
name. You may select as many components as you wish. If
you are using analog acquisition with an SS420x, select
Generic System.
4. Press the Submit button to finish. If this is the first
installation, after selecting the components and clicking
Submit, click the Install Now button. You will be prompted
to confirm the installation. If this is not the first installation,
go to the Advanced tab and click Restart. The system will
display the “Installing” message. The AIC will “beep” when
the installation is complete. Wait until the “Ready” message
is displayed to continue.
Configure the SS420x
If you will be using an SS420x attached to the Agilent Instrument
Controller (required for analog acquisition), it will need to be
configured using the OL software, as described below. If you are not
using an SS420x, you may skip this section.
1. From OL, select the Administration tab and then click
Global Administration followed by Agilent Instrument
Controller.
2. Double-click the name of the Agilent Instrument Controller
where the SS420x is connected and then select the
Hardware tab.
3. Locate SS420x under Boards and then click Configure.
4. From the SS420x configuration dialog, select the Serial port
to which the SS420x is connected and then check the
Installed box to enable the configuration of the interface.
Then proceed to select the appropriate settings for the
interface.
Installing the AIC 5000 9