User`s guide

must have its own trigger configured. When completed, click
OK.
SS420x Ready Configuration
To configure a Ready signal, select Ready for Name, set
SS420x for the Source, and then click Setup. The following
dialog will appear.
Select the Serial Port and the relay to be used for the Ready.
These should match the physical connections on the SS420x
interface for this ready line. Then select the state of the relay
when it is in the ready position.
SS420x Valve/External Event Configuration
To configure a Valve or other external event to control from
the SS420x, enter a descriptive name in the Name field and set
SS420x for the Source. Then click Setup and the following
dialog will appear.
SS420x User’s Guide 29