User`s guide

Sampling frequencies available in the Acquisition Setup portion
of the method will reflect the Base Frequency selected.
Range
For each channel used, select the button next to the signal range
for the detector connected to that channel.
Information
This area is for information only. It contains manufacturing
information about the interface box that may be required in
service situations. If the box is not recognized, the “Connection
Status” field will display “Not Connected”.
Read SS420x Settings
Click this button to read the current SS420x settings and update
the current display.
When you have finished changing the SS420x settings, click the
Submit button.
SS420x Acquisition Configuration
Each instrument using the SS420x for acquisition must be
configured to use the interface. This is done when configuring
the instrument and its detectors. To start the configuration of
an instrument with an SS420x,
1. Select the instrument's location on the Instruments Tab.
Icons for all instruments in that location will appear.
2. Click on the instrument's icon. An instrument status
screen will appear in the right-hand pane.
3. Select
Configure Instrument in the Select Task section.
4. In the
Instrument name box, type the name of the
instrument (for identification only), and then select the
Instrument type for this instrument (Generic if no
instrument control option will be used.)
5. Click the Agilent Instrument Controller button and then
select the Agilent Instrument Controller box to which this
instrument is attached from the list displayed, followed by
the
OK button.
The Instrument Configuration dialog will appear.
SS420x User’s Guide 25