User`s guide

7 Configuration for OpenLAB
If you will be using an SS420x attached to the Agilent
Instrument Controller (required for analog acquisition), it will
need to be configured using the OpenLAB software, as
described below.
1. From OpenLAB, select the
Administration tab and then
click
Global Administration followed by Agilent
Instrument Controller Network Appliance
.
2. Double-click the name of the Agilent Instrument Controller
where the SS420x is connected and then select the
Hardware tab.
3. Locate SS420x under
Boards and then click Configure.
4. From the SS420x configuration dialog, select the Serial
port to which the SS420x is connected and then check the
Installed box to enable the configuration of the interface.
Then proceed to select the appropriate settings for the
interface.
SS420x Interface Configuration
From the SS420x configuration dialog, select the Serial port to
which the SS420x is connected and then check the Installed
box to enable the configuration of the interface. Then proceed
to select the appropriate settings for the interface.
SS420x User’s Guide 23