User`s guide

SS420x Trigger Configuration
Select Trigger in the Name column. Select SS420x for Source.
Then click Setup. The following dialog will appear.
Select the correct Serial Port, trigger number, and initial
trigger state for this trigger. Note: If multiple SS420x boxes
being controlled from the same instrument (each box is on its
own serial port), and external triggering is desired, each box
must have its own trigger configured. When completed, click
OK.
SS420x Ready Configuration
To configure a Ready signal, select Ready for Name, set
SS420x for the Source, and then click Setup. The following
dialog will appear.
SS420x User’s Guide 21