User`s guide

SS420x Channel Configuration
For the detector selected, set the correct Serial Port, and
Channel to be used. These should match the way your detector
is physically connected to the SS420x interface.
When you have finished this dialog, click OK.
SS420x Event Configuration
If you plan to use event control from the SS420x, you must
configure it for each instrument using the SS420x. From the
generic system configuration box, make sure the Event
Configuration icon is shown in the Configured Modules area.
(If not, double-click on the icon to move it over to the
Configured Modules area.)
SS420x User’s Guide 19