User`s guide

6 Configuration for EZChrom Elite
In order to use an SS420x for data acquisition, you must
complete the configuration steps shown below. First,
configure the board using the Tools/Interface
Configuration… command from the Main menu. Then, for
each instrument using the SS420x for acquisition, you must
configure the detector for using the SS420x interface, as
described in the following sections.
SS420x Interface Configuration
From the Main menu, click Tools/Interface Configuration….
A dialog will appear with available interfaces shown.
Click on the SS420x icon, then click Properties.
SS420x Configuration
From the SS420x configuration dialog, select the Serial port to
which the SS420x is connected and then check the Installed
box to enable the configuration of the interface. Then proceed
to select the appropriate settings for the interface.
SS420x User’s Guide 15