User`s guide

Manual Updates
The following updates have been made to this manual since the November 1997 printing
indicated on the Printing History page.
7/8/99
The Isink rating referred to on page 20 has been corrected. Additional information about CV mode
operation has also been added to this page.
Notes have been added to Table A-1 for the Ripple and Noise specifications as well as the DC
Measurement Accuracy Voltage specification.
A note has been added to table A-2 for the OVP Accuracy characteristic, and the Isolation to Ground
characteristic has been corrected.
Steps 19 and 20 on page 61 under Low Range Current Measurement Calibration have been switched.
1/7/00
All references to HP have been changed to Agilent.
All references to HP-IB have been changed to GPIB.
A note about magnetic fields has been added to page 22.
On page 49 the model reference for note 3 has been corrected.
2/21/01
Fuse part numbers on page 21 and 68 have been corrected.
A note has been added to Table A-1 for the Programming Accuracy specification.
4/11/03
The Canada ICES/NMB-001 statement has been added to page 3.
A correction has been made to the Programming Accuracy note in table A-1.
10/2/03
The Ripple and Noise specification for Model 6614C has changed in table A-1.