Specifications

60
Command Processing Time: Average time
required for the output voltage to begin
to change following receipt of digital
data is 20 ms for the power supplies
connected directly to the GPIB.
(Display disabled.)
Output Voltage Rise Time/Fall Time:
100 ms/200 ms for output to change from
90% to 10% or from 10% to 90% of its total
excursion with full resistive load
(excludes command processing time).
Modulation: (Analog programming of
output voltage and current)
Input Signal: 0 to -4 V for voltage
and current
Input Impedance: 60 k Ohm nominal
Input Power: 3800 VA, 2600 W at full load;
100 W at no load
GPIB Interface Capabilities: SH1, AH1, TE6,
LE4, SR1, RL1, PP0, DC1, DT1, E1 and
C0. IEEE-488.2 and SCPI-compatible
command set
Software Driver:
•IVI-COM
•VXIPlug&Play
Regulatory Compliance: Listed to UL1244;
certified to CSA556B, conforms to
EN61010.
Warranty Period: One year
Size: 425.5 mm W x 132.6 mm H x
640 mm D
See page 102 for more details
Weight: 27.7 kg (61 lbs) net,
31.4 kg (69 lbs) shipping.
Ordering Information
Opt 200 174 to 220 Vac, 47 to 63 Hz
(Japan only)
Opt 230 191 to 250 Vac, 47 to 63 Hz
* Opt 908 Rack-mount Kit (p/n 5062-3977)
* Opt 909 Rack-mount Kit w/Handles
(p/n 5063-9221)
Single-Output: 2000 W GPIB
(Continued)
More detailed specifications at www.agilent.com/find/E4356
High Performance DC Power Supplies speed and accuracy for test optimization
Opt 0L1 Full documentation on
CD-ROM, and printed standard
documentation package
Opt 0L2 Extra copy of standard
printed documentation package
Opt 0B0 Full documentation on
CD-ROM only
Opt 0B3 Service Manual
A line cord option must be specified,
see the AC line voltage and cord section.
* Support rails required
Accessories
p/n 1494-0059 Accessory Slide Kit
p/n 1252-3698 7-pin Analog Plug
p/n 1252-1488 4-pin Digitial Plug
p/n 5080-2148 Serial Link Cable
2 m (6.6 ft)
E3663AC Support rails for
Agilent rack cabinets
Agilent Models: E4356A
To p
Side
425.5mm
16.75"
574mm
22.6"
640mm
25.4"
68mm
2.67"
132.6mm
5.2"
145.1mm
5.71"
Rear
12.7mm
0.5"
128mm
5.04"
Accepts Wire
AWG 12-22
1/4" x 1" untreaded
hole on each bussbar
Note: Buss Bar is 1/8" thick cu
1.25"
0.75"
0.31 dia"
1.0 "
0.5 "
IM
VP
+IP
-IP
+P
+S
-S
-LS +LS
Rear Connector Detail
Buss Bar Detail