Service manual

1
General Information
C
The Cables
The Hewlett-Packard 85133E/F flexible test port return cables
(Figure l-l) are designed for use with HP 8510 network analyzer
tests sets that have male NMD-2.4 mm test ports (such as the HP
8516 and 8517).
HP 85133E This is a single cable. Use it when a DUT (device under test) is
connected, with the appropriate adapter, directly to the test set test
port (see Figure l-la).
HP 85133F This is a set of two cables; each is shorter than the HP 85133E cable.
Use these cables when a DUT is connected between cable ends (see
Figure l-lb).
Network Analyzer
Test Set
Device
Undet
TiSSt
a
Network
1 v Netw~w& kmiyter v 1
w
g
w
I I
I I
Cable Set Cable Set
DeviceDevice
UnderUnder
TestTest
0-l0-l
bb
.
Figure 1-l. Cable Configurations
Note
This manual assumes you know how to properly care for coaxial
connectors. If not, refer to Hewlett-Packasd’s Microwave Connector
Cam for details (see Chapter 4 for ordering information).
HP 85133E/F