Service manual

Supplemental
Characteristics
Table 2-3 lists supplemental performance characteristics. These are
not specifications, but are intended to provide additional information
useful to your application. Supplemental characteristics are typical
(but not warranted) performance parameters.
Table
2-3. Supplemental Characteristics (1 of 3)
Approximate
Cable
Ele&kil
Magnitude Magnitude
Recommeuded
HP Length Length and and
Bend Radius
Cable cm in m ft
Phase Stabil$J*
1
Phase Stability13 cm in
A
85133E
97.2 38.25 1.125 3.690 ~0.25 dB Change <0.15 dB Change
10.2 4
~0.16~ (f)+0.8’ <O.O8O (f)+O.SO
85133F 62.9 24.75 .7376 2.418 <0.17 dB Change <0.12 dB Change
1
<0.16' (f) +0.8O <0.08’ (f) +0.8O
l(f)=fkeqpencyinGHz
2 With a 90°, four4nih bend radius.
3 after three 9o”, four-inch bend radius/straighten cycles.
Table 2-4. Supplemental Characteristics (2 of 3)
HP
Number of Test Set Eud DUT End
Cable Cables
connector Type
coImector Type
85133E 1
r
NMD-2.4 rmqf) PSG2.4 mxqf)
85133F 2
4
NMD-2.4 mrqq NMD-2.4 mm(,) and PSG2.4 mm(f>
4
24. Supplemental Characteristics (3 of 3)
l
Center Conductor
1
PNtCiSiOIl
Allowable Recession1 Allowable Protrusion
Connector
in in
NMD-2.4
mm(f)
0.0000 to
0.056 0.0000 to 0.0022
0.0000
0.0000
r
NMD-2.4 mm(,) 0.0025 to
0.0127 0.0001 to 0.0005
,PSG2.4 mm/fl
,O-0025 to
0.0127,0.0001
to 0.0005,
I
1
1 Center conductor shoulder behind outer conductor matiing plane,
2-2 Specifications
HP 85133EJF