User manual

Instructions for Use
Maintenance
4
MiniVac Controller User Manual / 87-900-049-01 (H) 47/70
Starting the Pump
The pump is activated only if the controller is powered on and the
pump itself is connected to the output connector. For further
information refer to the “Technical Information” section.
Pump Shutdown
To shutdown the pump, turn the main switch placed on the front
panel to OFF.
Maintenance
The MiniVac series controllers do not require any maintenance
interventions. Any intervention must be performed by authorised
personnel only.
When a fault has occurred it is possible to use the Agilent repair
service or the “Agilent advance exchange service”, that allows to
obtain a regenerated controller replacing the faulty one.
WARNING!
Before carrying out any work on the controller, disconnect it from the supply.
NOTE
Pins 3 and 7 on the loopback plug provided with the unit are short circuited
(Remote ON/OFF). This loopback plug must be fitted to power on the HV unless
a Remote/Interlock contact is connected.