Technical data

156 6000 Series Oscilloscopes Service Guide
6 Replacing 6000L Assemblies
To remove the power shaft
1 Perform the previous procedures:
• “To remove the bottom cover” on page 145
• “To remove the power supply” on page 150
• “To remove the fan” on page 152
2 Use a flat- blade screwdriver to gently spread the latch
while pushing the power shaft forward.
Figure 57 Removing the power shaft.
3 Lift and remove it from the deck.
4 When reinserting the power shaft, push the shaft into the
power switch until the shaft snaps onto the switch.
CAUTION
Twisting the latch too much could cause it to break!
6000_series_service_guide.book Page 156 Friday, March 23, 2007 2:43 PM