Technical data

Replacing 6000L Assemblies 6
6000 Series Oscilloscopes Service Guide 151
4 Using a T10 Torx driver, remove the 2 screws securing the
power supply to the chassis.
5 Using a flat- blade screwdriver through the hole in the
divider, gently pry the power supply board up enough to
snap the power supply board off the rear snap fastener.
6 Using a twisting motion, with a flat- blade screwdriver
gently snap the power supply board off the front snap
fastener.
7 Reverse this procedure to install the power supply.
6000_series_service_guide.book Page 151 Friday, March 23, 2007 2:43 PM