Technical data

Replacing 6000A Assemblies 5
6000 Series Oscilloscopes Service Guide 141
10 Using the T10 TORX driver, remove the five screws that
hold the system board to the deck.
Figure 47 Removing the system board
11 Lift the back of the board to clear the main deck and
then gently pull the board straight out.
T10 Screws
Hex Standoffs
Hex Nuts
& Washers
Intensity Knob
(not shown)
6000_series_service_guide.book Page 141 Friday, March 23, 2007 2:43 PM