Technical data

138 6000 Series Oscilloscopes Service Guide
5 Replacing 6000A Assemblies
4 Slide the fan mount to the side to remove the 4 retainer
hooks from their keyholes and lift out.
It may help to push on each of the hooks to keep from
tearing them.
5 Peel the rubber fan mount off the corners of the fan.
Figure 45 Removing the fan
6 Reverse this procedure to replace the fan assembly.
• When re- installing, note the position of the tab on the
fan mount and the direction of the fan cable.
• Ensure that the assembly is locked into the keyholes
Keyholes
in deck
Fan
Fan mount
Fan mount tab
Fan cable
6000_series_service_guide.book Page 138 Friday, March 23, 2007 2:43 PM