Technical data

130 6000 Series Oscilloscopes Service Guide
5 Replacing 6000A Assemblies
To remove the power shaft
1 Perform the previous procedures:
• “To remove the cabinet” on page 104
• “To remove the power supply shield” on page 125
2 Use a flat- blade screwdriver to gently spread the latch
while pushing the power shaft forward.
Figure 40 Removing the power shaft latch
3 Lift and remove it from the deck.
4 When reinserting the power shaft, push the shaft into the
power switch until the shaft snaps onto the switch.
CAUTION
Twisting the latch too much could cause it to break!
6000_series_service_guide.book Page 130 Friday, March 23, 2007 2:43 PM